Instructions
1. Pinch the corrugated plastic tube so that it is flat.
2. Insert the tube into the F hole.
Note: Be careful to get the tube as flat as possible and insert/remove slowly as not to
damage the instrument.
3. Position the mounting bracket to side of instrument
4. Tighten the 2 turnbuckle adjusters on each side of the bracket using bracket key.
5. Clip the microphone to the corrugated tube facing the F hole.
6. Clip microphone on/off switch to the bracket. Make sure you have placed the
battery into the on/off switch.
7. Plug the microphone 1/4” plug into the top of the instrument cable coupling
that is attached to the bracket.
8. Plug a 1/4” instrument cable to the other end of the instrument coupling.
9. Plug into an amplification system and you’re ready to play!
2. Insert the tube into the F hole.
Note: Be careful to get the tube as flat as possible and insert/remove slowly as not to
damage the instrument.
3. Position the mounting bracket to side of instrument
4. Tighten the 2 turnbuckle adjusters on each side of the bracket using bracket key.
5. Clip the microphone to the corrugated tube facing the F hole.
6. Clip microphone on/off switch to the bracket. Make sure you have placed the
battery into the on/off switch.
7. Plug the microphone 1/4” plug into the top of the instrument cable coupling
that is attached to the bracket.
8. Plug a 1/4” instrument cable to the other end of the instrument coupling.
9. Plug into an amplification system and you’re ready to play!
Steps 1 & 2
Steps 3 & 4
Steps 5,6 & 7